Product Specifications
- Brand
- Carlo Gavazzi
- Part Number
- DUB01CD48500V
- Type
- Voltage Monitoring Relay
- Power Supply
- 24 to 48 VAC/DC
- Output
- 8A SPDT relay
- Functions
- Over or undervoltage, adjustable delay, latching/inhibit
- Documents
- Product Specs
Product Description
The order code DUB01CD48500V names the whole device: DUB01 for the rail-mounted series, C for voltage monitoring, D48 for a 24 to 48 V AC or DC supply, and 500V for the measuring range. A DIP switch sets overvoltage or undervoltage watching on a single phase, with true RMS measurement on both AC and DC. The threshold spans 10 to 110% of full scale and the hysteresis is set between 0 and 30% of that threshold.
Delay, latch and inhibit are set on the device
The adjustable delay runs from 0.1 to 30 s, which is what keeps a brief sag from tripping the output. DIP switch four chooses between latch and inhibit: with latch enabled the output holds in the ON state after an alarm, and with inhibit enabled the output is held off during maintenance or transfer. The green LED shows supply. The red LED shows alarm. It flashes at 2 Hz while the delay runs. The yellow LED shows the output relay state. The SPDT contact carries 8 A at 250 V AC under AC-1, or 5 A at 24 V DC under DC-12, so the load side has to be checked against the utilization category rather than the headline current alone.
The housing is 22.5 mm wide on DIN rail to EN 60715, so a bank of these relays occupies little space in a panel even when each channel needs its own threshold and its own delay setting, which is the usual case when several supply points on one line are monitored independently. Setting the threshold against the 500 V range and then choosing the delay on the device means the relay can be commissioned without a separate controller. The supplier sheet for the 115 to 230 V AC version uses a different order code, DUB01CB23500V, and is not interchangeable with the D48 supply described here.
Single-Phase Voltage Monitoring Relay | Carlo Gavazzi DUB01
Product Specifications
- Brand
- Carlo Gavazzi
- Part Number
- DUB01CD48500V
- Type
- Voltage Monitoring Relay
- Power Supply
- 24 to 48 VAC/DC
- Output
- 8A SPDT relay
- Functions
- Over or undervoltage, adjustable delay, latching/inhibit
- Documents
- Product Specs















