12 month warranty Request a Quote Technical Support
Sign In

UG-8 vs 2301E vs EPG: Three Woodward Governor Routes Compared

Nov 21, 2026
KY Automation
Technical Knowledge
Contents [hide]

    A genset needs its speed held, and three Woodward routes hold it with different physics: the UG-8 mechanical-hydraulic governor, the 2301E digital control, and the EPG electric governor. The choice is not a generation question. It follows the site, the fuel system and the panel that is already there.

    The UG-8 governs without outside power

    The UG-8 carries its own oil sump and an internal pump driven from the governor shaft, and because the governing energy comes from the engine rather than the panel, it keeps controlling through a blackout while dashpot compensation lets it run isochronous or droop for load sharing. Flyweights in the ballhead sense speed, and a pilot valve moves the terminal shaft against 827 kPa of oil pressure, delivering 13.2 N·m over 42 degrees of travel.

    The cost is mechanical. Oil changes and linkage wear belong to the maintenance schedule.

    The 2301E adds load sharing and diagnostics

    The 2301E is a digital load sharing and speed control for diesel and gaseous engines. It takes a magnetic pickup and an electric actuator, holds isochronous load sharing across paralleled sets, and exposes dynamics, start fuel and protection settings through configuration software. Modbus RTU over RS-422 lets a plant system read the unit without extra hardware.

    What it needs is a clean DC supply and an electrified panel. Where those exist, the accuracy and the diagnostics are not comparable with a ballhead governor.

    The EPG deletes hydraulics from the actuator

    An EPG system is three components: actuator, speed control and magnetic pickup. The actuator needs neither mechanical drive nor hydraulic supply, delivers up to 2.3 J of work, and runs on 12 or 24 V. Isochronous and droop controls are both available, with a start fuel limit for smoke control.

    The limit is actuation energy. A 2.3 J actuator suits a low-mass, low-friction fuel linkage on a smaller engine, and a stiff rack on a large engine sits outside that class.

    Site conditions sort the three. No reliable power or a classified area points to the UG-8, because it governs without the panel. An electrified plant that needs tight frequency and load sharing points to the 2301E. A small engine with a light linkage and no hydraulic supply points to the EPG.

    Contents