XE01-1AB0 is the PROFINET entry point of the SINAMICS G115D XE0x sub-series — 1.1kW FSA with full PROFINET capability. This is the lowest-power XE0x PROFINET drive confirmed to date. With XE01-1AB0, the XE0x PROFINET path now spans 1.1kW through 7.5kW across all three G115D frame sizes — a single catalog family covering the entire conveyor power spectrum with one Ethernet protocol from the compact FSA enclosure to the high-power FSC.

At 1.1kW, this drive handles the most common conveyor zone motor — accumulation, transport, and light transfer. PROFINET at this power level enables per-zone energy monitoring, predictive maintenance on drive loading, and centralized parameter management across hundreds of zones. The integrated 2-port switch daisy-chains from drive to drive — no external switches needed between adjacent zones. PROFIsafe provides STO over the same Ethernet cable.

Why PROFINET at the 1.1kW level?

In a distribution center with 300+ conveyor zones, the majority are 1.1kW or below. PROFINET at this level is not about the individual drive — it is about network economics at scale. Daisy-chain topology eliminates one Ethernet switch per zone. Centralized parameter download (SD card or PROFINET) eliminates manual configuration per drive. PROFIsafe eliminates a safety relay and safety wiring per zone. At 300 zones, these per-unit savings compound into significant installed-cost reduction. XE01-1AB0 is the XE0x catalog path to these scale economics at the most common conveyor power level.

How does XE01-1AB0 relate to XE41-1AB0?

Same 1.1kW FSA hardware, same PROFINET interface, same 3.1A rated / 6.2A overload, same 3.95kg IP65 enclosure. XE01 uses the XE0x sub-series catalog digit; XE41 uses the XE4x catalog digit. The sub-series distinction is Siemens commercial organization — the drives are mechanically and electrically identical. Either PN can be cross-referenced in procurement.

Frequently Asked Questions

Is there an XE01-1AA0 variant?

XE01-1AA0 (I/O Control at 1.1kW) is structurally expected but not yet observed. XE01-1 is confirmed with AF0 and AB0; XE01-5 carries all three communication variants. If the application needs basic I/O control at 1.1kW via the XE0x catalog path, XE01-1AA0 is the code to look for — or cross-reference XE41-1AA0 (XE4x sub-series) or 1XA01-1AA0 (1XA0x sub-series) which are confirmed.

Can I mix XE01 drives with XE02 and XE03 on the same PROFINET network?

Yes. The G115D PROFINET interface is identical across all power ratings and frame sizes. XE01-1AB0 (1.1kW FSA), XE02-2AB0 (2.2kW FSB), XE03-0AB0 (3kW FSB), and XE05-5AB0 (5.5kW FSC) all share the same PROFINET device profile, the same GSDML file, and the same commissioning workflow in TIA Portal. A single PROFINET controller manages the full mixed-power drive population.