The 6SL3520-0XL02-2AB0 is the basic I/O variant at the 2.2 kW power tier — the most cost-effective SINAMICS G115D configuration for small conveyor drives where all sensor and actuator logic resides in the central PLC. It delivers 11.8 A at 480 V 3-phase from the standard IP65/66 FSB enclosure with integrated C2 EMC filter, PROFINET/EtherNet/IP communication, and STO safety, without the additional on-board I/O of the higher-tier variants.

When is the basic 2.2 kW G115D the optimal choice?

At 2.2 kW, the G115D typically drives short belt conveyors, transfer stations, or diverter units in material handling systems. These applications often need only two signals from the drive — run/stop and speed reference — both sent over PROFINET from the central PLC. When proximity switches, photoelectric sensors, and actuator outputs for the same conveyor segment are wired to a nearby ET 200AL or ET 200eco PN remote I/O block, the drive's on-board I/O is redundant. The basic (-0AB0) variant saves cost without sacrificing any function that is actually used.

What distinguishes the 2.2 kW power point?

The 2.2 kW rating with 11.8 A output covers the majority of small to medium conveyor drive applications — roller beds up to approximately 10 meters, belt conveyors carrying parcel and package loads, and transfer carriages in sorting systems. It sits between the 1.5 kW entry-level and the 3 kW mid-range, providing enough starting torque for loaded conveyors while remaining in the FSB frame with a consistent 134 mm depth.

Frequently Asked Questions

Can I later swap a basic 2.2 kW drive for a higher-tier variant?

Yes. All G115D FSB-frame drives share identical mounting hole patterns, connector positions, and PROFINET configuration. A basic (-0AB0) drive can be mechanically and electrically swapped for a standard or full-featured variant of the same power rating with no mechanical rework or network reconfiguration beyond importing the new device's GSDML file.

Does the basic variant include a brake chopper for motor holding brakes?

The G115D provides a 180 V DC brake output for SIMOGEAR motor holding brakes. This is a series-standard feature independent of the I/O tier — the basic variant includes it.